Strapless Face Mask
The ONLY Strapless and Anti-fog FaceWear.
No more foggy glasses or fumbling with ear loops or straps. These masks come pre-cut with a wax shield pre-installed. Click here for optional filter. The fabric is the same high-grade cotton kinesiology tape you know and love, designed to mimic your skin and allow for a comfortable, flexible fit.
Just snap, stick and go!
- This is a non-medical mask
- Facewear filter NOT included
- Available in 7 colours
- Wax paper shield
- Strapless comfort
- Anti-fog for eyewear
- 100% poly-acrylic adhesive
- Great with SpiderTech Face Protection Strips!**
Product Measurement (Width x Length)
10cm x 24cm
4" x 9.5"
How to Apply
How to Adjust
How to Remove
Can you adjust the tackiness of the glue?
Before you stick/apply the mask on the face, touch the glue in the area where you want less adhesion. Note that the glue loses its stickiness the more you touch it. It reacts differently on all skin as some skin is dry, some oily, some with makeup, etc.
How do you remove the face mask?
When removing the Ready to Wear Face Mask, start in the upper right or left corner. With one hand, pull your exposed skin beside the mask towards your ear, tightening your skin. With the other hand, gently roll the corner of the mask down and in towards your mouth. Repeat on the opposite side and then gently roll the mask down the bridge of your nose.
Can the face mask be worn with facial hair?
The Ready to Wear Face Mask is great for people with facial hair. Because the bottom strip of filter paper can remain attached covering the adhesive you can wear the mask like a face shield and avoid uncomfortable pressure on your facial hair.
How long can you wear the mask for?
The Ready to Wear Face Mask can be worn the entire day. It can be removed and reapplied. Just note that every time you remove the mask, the adhesive will lose some strength.
Are the masks reusable and can it be washed?
Our Ready to Wear Face Mask can be folded or stuck on to your clothing for later use
What is the filter made of?
The filter in our Ready to Wear Mask is the backing paper of our kinesiology tape. The backing is a wax paper that works exceptionally well shielding droplets and particles. The mask has been independently lab tested and proved to have a Bacterial Filtration Efficiency of over 99%.
What is the bacterial filtration efficiency?
The bacterial filtration efficiency of our Ready to Wear Mask is 99.09%
How does it compare with the N95 mask?
The Ready to Wear Face Mask is a different type of mask and as a result not comparable to a N95 or other respirator masks. Our mask acts like a shield over your nose and mouth providing an effective protective barrier. Respirator masks effectively filter the air as it comes into the mask.
What if I find it hard to breathe in the mask?
The Ready to Wear Mask provides the option to seal the bottom of the mask or to leave it open allowing it to act like a face shield. The face shield option provides excellent protection and breathes even easier than the fully sealed option.
What if the mask adhesive Irritates my Skin?
The masks use a high quality acrylic, hypoallergenic adhesive designed to be worn on sensitive facial skin, however, a low percentage of people will still experience a sensitivity reaction. If you are one of the people who has a reaction to the adhesive, please remove the mask immediately. Unfortunately the Ready to Wear Face Mask isn’t for you.